It's a freezing winter day and you awaken to a cold home. You quickly discover that the heating unit isn't working! Your first thought is to require emergency situation furnace repair.
Prior to you grab your phone, you can take a couple of basic steps to see if you might have the ability to fix the issue by yourself. This may help remedy the issue quicker and without the cost of a potentially unnecessary emergency furnace repair call.
1. Check your thermostat.
- Make sure that the thermostat is on and set to "heat." This sounds obvious, but you wouldn't believe how many service calls take place since the homeowner didn't know that someone (like a visitor or child) changed the settings!
- If your thermostat has a fan setting, set it to "automobile" rather of "on." Otherwise, the fan might blow constantly even when the air isn't being heated up.
- If the room temperature level is lower than the thermostat setting, attempt adjusting the establishing a couple of degrees to see if the heater begins.
2. Make sure you have power to the heating system.
Even if you have a gas heating system, a disruption in electrical power will interrupt your furnace from producing heat. You might have a breaker that https://furnace-repair-calgary.ca has actually tripped.
If that's the case, you can reset it by turning the circuit all the way off and then on again. If the circuit immediately breaks again, call a professional.
3. Check your air filter.
An air filter that is very stopped up will not enable the air to be warmed correctly. It may trigger your heating system to get too hot and close down.
Remove the filter and hold it against the light. Can't see any light through it? Replace it. We advise inspecting your heater filter each month and replacing as required.
4. If you have a gas heating system, make sure the gas supply is on.
If you have actually had any repair work done lately, someone may have turned off the gas supply valve and then forgot to turn it back on. Or, the gas company might have closed down the gas lines for upkeep. A fast contact the gas company is a good idea if you think this may hold true.
- Check the gas valve at the gas company's meter.
- Inspect the gas valve on your heating system. Your heating system's gas valve is on when the handle is inline (parallel) with the pipeline. If it's off, the deal with will be perpendicular to the pipeline.
If you smell gas, shut off the supply and immediately call a professional.
5. Examine the ignition source or pilot burner.
Most contemporary heating systems have actually an igniter coupled with a flame sensing unit instead of a physical pilot light. Both of these can wear and require repair. In fact, ignitor and flame sensing unit problems are some of the most typical heating system repair work we experience.
If you have an older heater, your unit may have a physical pilot light. A draft or disruption in gas service can cause the pilot burner to head out. If your pilot burner is out, and you have actually currently verified that you have a safe gas supply, attempt relighting it according to your owner's manual. (This is usually finished with a fireplace match or long barbeque-style lighter.).
If you're not comfy with this, or the pilot burner won't remain lit, call a technician.